操作箱通用技术规范本规范对应的专用技术规范目录序号名称编号1操作箱专用技术规范1101028-0220-0330-0500-0750-01操作箱采购标准技术规范使用说明1.本标准技术规范分为通用部分和专用部分。2.项目单位根据需求选择所需设备的技术规范。技术规范通用部分条款、专用部分标准技术参数表和使用条件表固化的参数原则上不能更改。3.项目单位应按实际要求填写“项目需求部分”。如确实需要改动以下部分，项目单位应填写专用部分“项目单位技术差异表”，并加盖该网、省公司物资部（招投标管理中心）公章，与辅助说明文件随招标计划一起提交至招标文件审查会：1）改动通用部分条款及专用部分固化的参数；2）项目单位要求值超出标准技术参数值范围；3）根据实际使用条件，需要变更环境温度、湿度、海拔高度、耐受地震能力、用途和安装方式等要求。经招标文件审查会同意后，对专用部分的修改形成“项目单位技术差异表”，放入专用部分表格中，随招标文件同时发出并视为有效，否则将视为无差异。4.投标人逐项响应技术规范专用部分中“1标准技术参数”、“2项目需求部分”和“3投标人响应部分”三部分相应内容。填写投标人响应部分，应严格按采购标准技术规范专用部分的“招标人要求值”一栏填写相应的投标人响应部分的表格。投标人还应对项目需求部分的“项目单位技术差异表”中给出的参数进行响应。“项目单位技术差异表”与“标准技术参数表”和“使用条件表”中参数不同时，以差异表给出的参数为准。投标人填写技术参数和性能要求响应表时，如有偏差除填写“投标人技术偏差表”外，必要时应提供证明参数优于招标人要求的相关试验报告。5.对扩建工程，如有需要，项目单位应在专用部分提出与原工程相适应的一次、二次及土建接口要求。6.采购标准技术规范范本的页面、标题等均为统一格式，不得随意更改。7.一次设备的型式、电气主接线和一次系统情况对二次设备的配置和功能要求影响较大，应在专用部分中详细说明。目次操作箱采购标准技术规范使用说明····················································································5271总则······················································································································5291.1引言··················································································································5291.2供方职责··············································································································5292技术规范要求···········································································································5292.1使用环境条件·········································································································5292.2装置额定参数·········································································································5292.3装置功率消耗······························································...
